|
| |
TM 5-4210-233-14&P-1
4-137. THERMOSTAT HOUSING-Continued
(2) Left-hand side:
(a) Remove three screws (9, 10 and 1 1), three lockwashers (12) and one flat washer (13).
(b) Remove thermostat housing (14) and gasket (15).
(3) Clean gasket material from thermostat housings (7 and 14) and from engine block.
b.
Installation.
(1) Right-hand side:
(a) Put new gasket (8) and thermostat housing (7) in position on engine block and secure with four
screws (1, 2, 3 and 4), four lockwashers (5) and one flat washer (6). Install flat washer (6)
on bolt (3).
(2) Left-hand side:
(a) Put new gasket (15) and thermostat housing (14) in position on engine block and secure with three
screws (9, 10 and 1 1), three lockwashers (12) and one flat washer (13). Install flatwasher (13)
on bolt (10).
c.
Follow-on Maintenance.
(1) Install water temperature sending units in left side thermostat housing (14) (see para 4-138).
(2) Install thermostats (see para 4-136).
(3) Connect batteries (see para 4-114).
(4) Close engine compartment covers.
4-402
|
