|
| |
TM 5-4210-233-14&P-1
4-63. HOSE BED FLOODLIGHT-Continued
b.
Cleaning and Inspection.
(1)
Clean light assembly.
(2)
Inspect for broken or cracked housing assembly. If damaged, replace light assembly.
(3)
Inspect wiring for fraying or cracked insulation. If wiring is damaged, contact Direct Support
Maintenance.
(4)
Inspect bulb socket, bulb contacts, and wiring for corrosion. Clean corrosion with emery cloth
(Item 25, Appendix E). If corrosion cannot be removed, replace light assembly.
(5)
Inspect switch and switch contacts for corrosion and proper operation. If damaged, replace
switch.
c. Assembly.
(1)
Install switch (6) and fasten to housing assembly with nut (5).
(2)
Attach wiring harness to switch (6).
(3)
Install springs (4) and secure sealed beam to ring (2).
(4)
Attach wire connectors to terminals of sealed beam (3).
(5)
Push ring (2) onto lamp head. Ensure lower lip on ring aligns with lamp housing indent.
(6)
Secure ring (2) with screw (1).
d.
Removal.
(1)
Remove four screws (7) securing lamp assembly (8) to hose body.
(2)
Cut wire (9) adjacent to butt connector. Cut butt connector from harness.
(3)
Remove lamp assembly (8) from hose body.
e.
Installation.
(1)
Attach wire (9) of new lamp assembly to wiring harness using new butt connector (Item 27,
Appendix E).
(2)
Align new lamp assembly (8) on hose body, and install with four screws (7).
f.
Follow-on Maintenance.
(1)
Connect batteries (see para 4-114).
(2)
Test operation of floodlights.
4-283
|
