|
| |
TM 5-4210-233-14&P-1
4-49. TANK DISCHARGE VALVE - Continued
c.
Cleaning and Inspection.
WARNING
Dry cleaning solvent P-D-680 is potentially dangerous.
Avoid repeated and prolonged breathing of vapors and
skin contact with the liquid. Do not use near open flame,
arcing equipment or other ignition sources. Always wear
eye protection and protective clothing. The flash point of
P-D-680 is 100 to 138 deg. F (38 to 59 deg. C).
(1)
Clean all parts in dry cleaning solvent (Item 3, Appendix E).
WARNING
Death or serious injury could occur if compressed air is
directed against the skin. Do not use compressed air for
cleaning or drying unless the pressure is/has been
reduced to 30 psi (2.11 kg/cm 2) or less. When working
with compressed air, always use chip guards, eye protec-
tion, and other personal protective equipment.
(2)
Dry all parts with compressed air.
(3)
Inspect valve body (7) for cracks and damaged threads. Replace as necessary.
(4)
Inspect ball valve (20) for grooves or cracks. Replace as necessary.
d.
Assembly.
(1)
Install stop brackets (24) and four socket head screws (23) (if removed).
(2)
Install new actuator shaft 0-ring (22) and actuator shaft (21). Apply a thin coat of silicone grease
(Item 11, Appendix E) to actuator shaft.
(3)
Fit ball valve (20) to actuator shaft (21).
(4)
Install new pivot bolt O-ring (19) and pivot bolt (18). Apply a thin coat of silicone grease (Item
11, Appendix E) to O-ring.
(5)
Install new seat O-ring (13) and new seat (12) in new seat retainer (10). Apply a thin coat of
silicone grease (Item 11, Appendix E) to O-ring.
(6)
Install new retainer O-ring (11). Apply a thin coat of silicone grease (Item 11, Appendix E) to
inside edge of seat retainer.
(7)
Use spanner wrench to thread seat retainer (1 0) clockwise into valve body (7) until tight.
(8)
Install handle (17) to original position.
(9)
Install handle washer (15), handle disc (16), and socket head screw (14).
4-252
|
