|
| |
TM 5-4210-233-14&P-1
4-43. #1 CROSSLAY VALVE - Continued
d.
Assembly.
(1)
Install new O-ring (25) in new seat retainer (21). Apply a thin coat of silicone grease (Item 11,
Appendix E) to inside edge of seat retainer (21).
(2)
Install new seat (23) in seat retainer (21).
(3)
Install new O-ring (22) in groove on outside edge of seat retainer (21). Apply a thin coat of
silicone grease (Item 11, Appendix E) to new O-ring (22).
(4)
Install new O-ring (20) on actuator shaft (19). Apply a thin coat of silicone grease (Item 11,
Appendix E) to actuator shaft (19).
(5)
Install actuator shaft (19) in valve body (6).
(6)
Install valve ball (18) in valve body (6).
(7)
Install new O-ring (17) on pivot bolt (16). Apply a thin coat of silicone grease (item 11, Appendix
E) to O-ring (17).
(8)
Install pivot bolt (1 6) in valve body (6).
(9)
Install seat retainer (21) in valve body (6). Screw seat retainer (21) in until some resistance is felt
when turning valve ball (18).
(10)
Install roll pin (15) and lock spring (14).
4-227
|
