|
| |
TM 5-4210-233-14&P-1
Table 4-1. Unit PMCS-Continued
Item
Interval
No.
W
M
S
A
B
ITEM TO BE INSPECTED/Procedures
7
STEERING ASSEMBLY - Continued
Steering Arm Drag Link
*
Inspect steering arm and drag link for any scoring, corrosion, bends, or
other damage. Carry out operational test to ensure steering geometry.
8
SUSPENSION SYSTEM
U-Bolts, Leaf Springs
*
Inspect visually for major damage. Replace as required (see para 4-163).
9
FRONT AXLE ASSEMBLY
Front Axle Assembly
*
Inspect visually for major damage. Report any damage to Direct Support.
Tie Rod Ends
*
Inspect tie rod end seals for indication of damage and ensure seals are
properly seated. Inspect tie rod for bends or serious dents. When wheels
are turned, the tie rod should move smoothly. Report any deficiencies to
Direct Support.
10
REAR AXLE ASSEMBLY
Rear Axle Assembly
*
Check for signs of oil leakage. Check vent lines are firmly attached and vent
is open.
11
AERIAL LADDER/WATER TOWER ASSEMBLY
Hydraulic Oil Tank
*
Check for signs of hydraulic oil leakage. Report any leaks to Direct Support.
Outrigger Beams
*
Inspect visually for signs of damage, scoring, cracks, or broken welds.
Report any deficiencies to Direct Support.
Outrigger Extend/Retract Cylinders, Outrigger Jack Cylinders
*
Check for hydraulic oil leakage. Report any leaks to Direct Support.
4-16
|
