|
| |
TM 5-4210-233-14&P-1
Table 4-1. Unit PMCS-Continued
Item
Interval
No.
W
M
S
A
B
ITEM TO BE INSPECTED/Procedures
ENGINE AND ACCESSORIES - Continued
Exhaust Manifold
WARNING
Severe Burns. Exhaust manifold surfaces may be hot. Avoid touching
surfaces; allow adequate cooling time before working on exhaust
system.
*
Inspect visually for any cracks. Check for loose attaching hardware, tighten
as required. Ensure connections to exhaust tubes are tight.
Thermostat Housing
*
Check for coolant leaks. Ensure attaching hardware is tight. Replace as
required (see para 4-137).
Engine Water Pump
*
Inspect visually for leaks. Ensure attaching hardware is tight. Refer to Direct
Support for replacement/repair.
Engine Oil Dipstick/Filler Tube
*
Inspect base of dipstick/filler tube for leaks. Ensure attaching hardware is
tight. Check crankcase oil level. Add proper engine oil as required.
Rocker Arm Covers
*
Inspect visually for leaks, check attaching hardware is tight. Replace gasket
biannually, or as required (see para 4-140).
Oil Pan
*
Inspect visually for leaks. Ensure attaching hardware is tight. Refer any
leaks to Direct Support.
5
WHEEL ASSEMBLY
Hubs, Bearing and Seals
*
Inspect visually for leaks. Ensure mounting hardware is in place and tight.
Check to see that front axle sight glass is intact and free of cracks.
*
Check oil level in front axle, fill as required. Change oil in front axle as
required; see lubrication instructions (para 3-1).
4-13
|
