|
| |
TM 5-4210-233-14&P-1
Contents
Para
Page
APU BRUSHES .................................................................................................. 4-208
4-520
APU ANTI-FLICKER POINTS AND RESISTOR .................................................. 4-209
4-522
APU PRIMARY FUEL FILTER ............................................................................ 4-210
4-524
APU SECONDARY FUEL FILTER ...................................................................... 4-211
4-525
APU OIL FILTER ................................................................................................. 4-212
4-526
APU AIR CLEANER ............................................................................................ 4-213
4-527
APU GLOW PLUG AND AIR INTAKE HEATER .................................................. 4-214
4-529
APU EXHAUST SYSTEM.................................................................................... 4-215
4-530
APU FUEL TRANSFER PUMP............................................................................ 4-216
4-532
APU OIL PRESSURE SWITCH........................................................................... 4-217
4-533
APU CRANKCASE BREATHER.......................................................................... 4-218
4-534
MITER BOX ........................................................................................................ 4-219
4-536
PREPARATION FOR STORAGE OR SHIPMENT ............................................... 4-220
4-541
SECTION I. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
4-1. COMMON TOOLS AND EQUIPMENT. For authorized common tools and equipment refer to the
Modified Table of Organization and Equipment (MTOE) applicable to your unit.
4-2. SPECIAL TOOLS, TMDE AND SUPPORT EQUIPMENT. There are no special tools, TMDE and support
equipment required for the fire truck.
4-3. REPAIR PARTS. Repair parts for this equipment are illustrated and listed in Appendix F of this manual.
SECTION II. SERVICE UPON RECEIPT
4-4. INTRODUCTION. This paragraph provides instructions for preparing a new, reconditioned, or recently
transported tuck for operation. Refer to Chapter 3, Lubrication Instructions and fluids.
CAUTION
Due to the critical nature of the service for which this vehicle is
intended, no vehicle should be placed in service if there is any
doubt or evidence of improper function of any of the
components or systems.
a.
Pump Body, Hose Body.
(1)
Inspect body for shipping damage; minor damage (e.g., scratches, small dents) should not affect
truck function. Major damage should be repaired prior to use and all items adjacent to the damage
should be thoroughly checked for correct operation.
(2)
Check all doors, latches, and hinges operate correctly; replace any which are defective. Refer to
para 4-71 and para 4-77 .
(3)
Check all lamps and beacons for dirty or broken lenses. Clean or replace as required. Refer to
para 4-61 through 4-66 .
4-5
|
