Cleaning and Inspection -706881018

TM 5-4210-233-14&P-1

5-59. OUTRIGGER JACK CYLINDERS - Continued

(5)

Remove gland (3) from rod (4).

(6)

Remove and discard wiper seal (8), rod seal (9), and gland O-ring (10).

(7)

Remove and discard two piston seals (11) androd O-ring (12).

(8)

Remove nylon plug (13) from tube assembly (2).

b. Cleaning and Inspection.

WARNING

Dry cleaning solvent P-D-680 is potentially dangerous. Avoid

repeated and prolonged breathing of vapors and skin contact

with the liquid. Do not use near open flame, arcing equipment

or other ignition sources. Always wear eye protection and

protective clothing. The flash point of P-D-680 is 100 to 138

deg. F (38 to 59 deg. C). (1) Clean all parts in dry cleaning

solvent (Item 3, Appendix E).

WARNING

Death or serious injury could occur if compressed air is directed

against the skin. Do not use compressed air for cleaning or

drying unless the pressure is/has been reduced to 30 psi (2.11

kg/cm 2) or less. When working with compressed air, always

use chip guards, eye protection, and other personal protective

equipment. (2) Dry all parts with compressed air.

(3)

Inspect inside of tube assembly (2).

If cylinder has deep grooves, score marks, or is severely

damaged, replace it.

(4)

Inspect rod (4). If rod (4) is bent, grooved, or pitted; replace it. Minor scratches can be removed

using emery cloth (Item 25, Appendix E).

(5)

Inspect gland (3) and piston (6). If gland (3) and/or piston (6) is cracked or broken; replace it/them.

(6)

Inspect rod lug (5). If rod lug (5) is cracked or broken, replace it.

5-348