Assembly-continued -706880971

TM 5-4210-233-14&P-1

5-43. FORWARD TANDEM AXLE AND DRIVE UNIT-Continued

(1)

Check the shim pack (80) that was removed during disassembly. Use a micro eter to measure

the thickness. Measurements should the same.

(2)

Place drive pinion (73) in a press, gear end down. Install bearing cone (81) on shaft and press into

position. Bearing cone (81) must contact face of pinion gear (73).

(3)

Install shims (80) and inner bearing cup (79) in differential carrier assembly (9). Press bearing cup

(79) into position.

(4)

Install the differential carrier assembly (9) in a press with legs of carrier at bottom of the press. Put

supports under carrier so that carrier is level. Install bearing cup (8) in bore of carrier.

(5)

Use a sleeve or bearing driving toot and press the bearing cup (78) into carrier. Press bearing cup

(78) in unfit bottom of cup touches bottom of bore.

5-301