Disassembly-continued -706880930

TM 5-4210-233-14&P-1

5-42. REAR TANDUM AXLE AND DIFFERENTIAL - Continued

(13) Match mark one carrier leg and bearing cap to aid in installing caps in same position when assembling

carrier.

(14) Remove cotter pins (2) holding the two bearing adjusting rings (3) in position. Use a small drift to

remove the pins.

(15) Remove four screws (4) and washers (5) securing bearing caps (6) to differential carrier. Remove

bearing caps and two adjusting rings (3) from carrier.

(16) Using a strap and a lifting device, lift main

differential from the carrier. Place the main

differential on a clean work bench.

(17) Check differential case halves for match

marks. If match marks are not visible, match

mark each case half with a center punch and

hammer.

(18) Remove sixteen screws (7) and washers (8).

Separate the case halves (9). Use a leather

or plastic mallet to loosen case halves.

(19) Remove two thrust washers (10), four thrust

washers (18), four pinion gears (12), two side

gears (13) and spider (14).

(20) Remove twelve nuts (15), washers (16) and screws (17) and separate ring gear (18) from case half

(9).

5-260