Installation-continued -706880830

TM 5-4210-233-14&P-1

5-23. TURBOCHARGER-Continued

(7) Install two screws (6) with lock

washers just enough to hold the

turbocharger tight against the

bracket.

(8) Position two clamps (3), one over air

inlet adapter (2) and one over

turbocharger (5).

(9) Tighten clamps (3).

NOTE

Secure the clamps with the "T"

section positioned away from the

parting line on the air inlet housing.

CAUTION

When installing the left bank exhaust manifold to turbocharger

tube on a blower mounted turbocharger, it is very important that

the tube is installed correctly. If the tube in installed incorrectly,

it can crack in the flange area and adversely affect performance.

(10)

The solid left bank tube is almost symmetrical, thus it is difficult to identify which end goes where.

Therefore, position the tube between the exhaust manifold and the turbocharger and check to

determine that the conical seat at each end of the tube is a flush fit with the openings. If not,

reverse the position of the tube and recheck to be sure each end of the tube is a flush fit with the

openings.

(11)

To help in the installation of the tube, loosen the exhaust manifold mounting bolts and then tighten

them alternately while tightening the tube clamps.

NOTE

Be sure the exhaust manifold remains seated on the locating

pads on the cylinder head.

5-160