Disassembly -706880666

TM 5-4210-233-14&P-1

4-219. MITER BOX - Continued

b. Disassembly.

(1) Remove four screws (1) and lock washers (2) to separate 900 housing assemblies (3).

CAUTION

Keep shims (4) together as a shim pack and use same

ones for assembly to maintain correct backlash of miter

gears if shaft and gear assemblies are reused.

(2) Remove shims (4).

(3) Use a 5/64" (2 mm) drift pin and hammer to drive out two locking pins (5).

(4) Remove two oil seals (6) by center punching to cock in bore and lifting out with a pliers. Discard

them.

(5) Use a spanner wrench to remove two bearing retaining nuts (7).

(6) Unscrew relief fitting (8) and grease fitting (9) from 900 miter housings (3).

4-537