|
| |
TRUCK SERVICE MANUAL
TM 5-4210-230-14&P-1
STEERING GEAR
41.
Assemble four screws (28) and torque to 16-30 Nm
(12-22 ft.lbs.).
42.
Assemble “O". ring (9B), seal ring (9C) and "O" ring
(9D) onto relief valve (9A), if applicable (Fig. 43).
43.
Assemble relief valve (9A) into valve housing (9), if
applicable and torque to 34-48 Nm (25-35 ft.lbs.).
44.
Assemble "O" ring (8) onto slipper (7) and assemble
both parts (with flat side of slipper out) into valve
housing (9). Assemble (steel) back-up washer (6)
into valve housing (9), use seal driver to push parts
into valve housing SE-2676 (Figs. 44 and 45).
Fig. 44
Fig. 45
45.
Assemble retaining ring (5) into valve housing (9)
with retaining ring pliers (Fig. 46).
46.
Assemble seal (4) into valve housing (9) and tap into
place with hammer and soft punch or use seal driver
SE-2675 (Fig. 47).
47.
Assemble seal (27) into trunnion cover (26) and tap
into place with hammer and soft punch (Fig. 48).
Fig. 46
Fig. 47
Fig. 48
CTS-2717 Page 14
PRINTED IN UNITED STATES OF AMERICA
|
