|
| |
TRUCK SERVICE MANUAL
TM5-4210-230-14&P-1
LUBRICATION
Symbol
Type Lubricant
G
Dexron Automatic Transmission Fluid
H
SAE-10W Engine Oil for temperatures -18 deg. C (0 deg. F) and up. For temperatures below
-18 deg. C (0 deg. F) use three parts SAE-10W engine oil to one part kerosene. The mixture
can safely be used in temperatures up to 0 deg. C (32 deg. F).
J
Lock Oil
K
SAE-10W-40 Engine Oil
L
Super Heavy Duty "DOT 3"
M
SAE-85W-140 Gear Lubricant or SAE-90 SP Type Lubricant, meeting MIL-L-2105B
Specification.
N
Penetrating Oil
O
WARNER
Engine Oil (SE, CC, CD)
SAE-30
Below
0 deg. C (+32 deg. F)
SAE-50
Above
0 deg. C (+32 deg. F)
Mineral Gear Oil
SAE-80
Below
-18 deg.
C ( 0 deg. F)
(Rust and Oxidation Inhibited)
SAE-80,90
Below
0 deg. C (+32 deg. F)
SAE-90,140
Above
0 deg. C (+32 deg. F)
P
Use straight mineral oil SAE-90 for temperatures -18 deg. C (0 deg. F) and up. Use SAE-80 for
temperatures below -18 deg. C (0 deg. F). Special recommendations: Where temperature is
consistently below -18 deg. C (0 deg. F) and where parked vehicles are exposed to unusual cold
for long periods, use SAE-75. Where temperatures are consistently above 32 deg. C (90 deg.
F) or unusually hot, use SAE-140 straight mineral oil.
Q
FULLER-NEW PROCESS
Engine Oil (SE, CC, CD)
SAE-30
Below
-12 deg. C (+10 deg. F)
SAE-40,50
Above
-12 deg. C (+10 deg. F)
Mineral Gear Oil
SAE-80
Below
-12 deg. C (+10 deg. F)
(Rust and Oxidation Inhibited)
SAE-90
Above
-12 deg. C (+10 deg. F)
R
SAE-30 heavy duty engine oil or rear axle gear lubricant.
S
SAE-20W-30 Engine Oil. Is compatible with symbol G.
T
Clean element when air restriction exceeds 51 cm (20 in.) of water or 3.8 cm (1.5 in.) of mercury.
Air Pressure Cleaning: Compressed air can be used to blow out the element from the clean air
side out.
Washing Procedure: . Filter element can be washed with any good non-sudsing, household
detergent. Use warm water 49 deg. 60 deg. C (120 deg. 140 deg. F). Flush filter with gentle
stream until drain water is clean. Air dry element before using. Also inspect after every cleaning
for damage or rupture. Wipe all internal parts clean before reassembling. Replace gasket
regularly.
CTS-2412S Page 2
PRINTED IN UNITED STATES OF AMERICA
|
