|
| |
TM 5-4210-230-14&P-1
CONTROLS
TWO-SPEED REAR AXLE SWITCH
A switch attached to the transmission control permits selection of either the high or low axle ratio. When the switch control
is pushed down, the axle is in low (power) ratio. When the switch control is pulled up, the rear axle is in high (speed) ratio. See
Vehicle Operation section for operating instructions.
VENT WINDOW LOCK
To open the vent windows, turn the lock clockwise and push the window outward to the position desired.
WINDSHIELD WASHERS
To operate the windshield washers, press in on the switch on the instrument panel to spray solution on the windshield.
Then, turn on the windshield wipers to clean the windshield.
Keep the fluid reservoir filled with IH windshield washer solvent.
WINDSHIELD WIPER CONTRO
Air and Electric)
Pulling the knob outward or turning the knob to the right starts either the air or electric wipers. Speed of the air wiper can be
regulated as desired by rotating the knob. The electric wiper has two speeds, "high" and "low".
IMPORTANT
To avoid damage to mechanism of the windshield wiper, DO NOT MOVE THE WIPERS BACK AND FORTH BY
HAND. Lift the blade outward when cleaning the windshield.
7
|
