|
| |
TRUCK SERVICE MANUAL
TM 5-4210-230-14&P-1
STEERING
Replace magnet in area shown (Fig. 5).
Place flow control valve spring into hole first and then insert flow control valve (Fig. 2).
4.
Install union seal on housing (Fig. 4).
5.
Lubricate inside edge of reservoir with power steering fluid and install on housing. Be careful to align union and stud holes (Fig.
3).
6.
Install new "O" rings on union and stud. Insert union and stud and tighten to specifications (Fig. 1).
SPECIFICATIONS
Pump Type
Vane
Manufacturer
Saginaw
Drive
Belt
Mounting
Bracket
Reservoir
Integral
Thrust Taken By
Thrust Plate
TORQUE CHART
DESCRIPTION
NEWTON METERS
(FT. LS.)
Pulley Nut
81
60
Pump Mounting Bolt
48
35
Flow-Control Fitting Assembly
48
35
Pressure Hose
48
35
CTS-2296R, Chapter 3, Page 11
PRINTED IN UNITED STATES OF AMERICA
|
