|
| |
TM5-4210-229-14&P
6.15
TRANSMISSION REPAIR (Continued)
(3) Assembly.
(a)
If cup plug (283) was removed from shaft (270),
install a new plug. Place the plug on the end of
main and output shaft orifice installer. Install
the plug into the output shaft just below the
chamber.
(b)
If bearing (282) was removed from shaft (270),
install a new bearing. Place bearing (282) on
output shaft bearing installer, numbered end of
bearing facing the tool. Attach driver handle to
the installer. Install the bearing into the output
shaft 0.370 inch (9.398 mm) below the face of
the
shaft.
(c)
If spring pin (280) was removed from shaft
(270), install a new pin. Press the pin into the
shaft until the pin's outer end is 0.150 to 0.170
inch (3.81 to 4.32 mm) from the shaft surface
adjacent to the pin.
(d)
If lubrication orifice plug (273) was removed
from main shaft (269), install a new one. Place
the orifice plug on the main and output shaft
orifice installer. Install the new orifice plug into
the main shaft. If the installer is not available,
press the plug into the shaft until it is recessed
0.140 to 0.180 inch (3.56 to 4.57 mm) below the
front end of the shaft.
(e)
Install ball bearing (279) onto the front of output
shaft assembly (278). Position the bearing
against spring pin.
(f)
Install shaft assembly (278) with bearing (279),
front end first, into the rear of rear planetary
carrier assembly (277). Tap the shaft until
bearing (279) contacts the carrier's rear hub.
6-78
TM5-4210-229-14&P
|
