|
| |
TM5-4210-229-14&P
6-15.
TRANSMISSION REPAIR (Continued).
(o)
Install valve (168), smaller end first, into valve
body (112).
(p)
Into the same bore, install spring (167) and
valve stop (165). Depress valve stop (165)
and install pin (166).
(q)
Install trimmer valve (131) open end first, into
valve body (112).
(r)
Into the same bore, install plug (127), springs
(119 and 120) and valve stop (115).
(s)
Install trimmer valve (132) open end first, into
valve body (112).
(t)
Into the same bore, install plug (128), springs
(121 and 122) and valve stop (116).
(u)
Install trimmer valve (133), open end first, into
valve body (112).
(v)
Into the same bore, install plug (129), springs
(123 and 124) and valve stop (117).
(w)
Install trimmer valve (134) open end first, into
valve body (112).
(x)
Into the same bore, install plug (130), springs
(125 and 126) and valve stop (118).
(y)
Install stop (137), spring (136), and valve
(135) into the bore.
(z)
Install cover (113) over the trimmer springs
and accumulator valve. Force the cover
against spring pressure, and install eight 1/4-
20x5/8 inch bolts (114). Torque the bolts to 9-
11 ft-lb (12-15 N.m).
(aa) Install valve (143) into valve body (112).
(bb) Into the same bore, install spring (141) and
valve stop (138). Depress stop (138) against
spring pressure, and install pin (140).
(cc) Install valve (144) larger end first, into valve
body (112).
(dd) Into the same bore, install spring (142) and
machined spacer (139). Depress the machined
spacer against spring pressure, and install pin
(140).
(ee) Install actuator rod (106) smaller end first, into
valve body (112). Install valve (105) longer
and first, into the same bore.
(ff) Install spring (104) and adjusting ring (103).
(gg) Depress adjusting ring (103) against spring
pressure, and install pin (98) so that it retains
ring (103).
(hh) Install valve stop (111), spring (110) and
priority valve (109) open end first, into valve
body (112).
(ii) Place separator plate (107) onto body (112) so
the bolt holes align. The slot in the separator
plate, must engage the flared end of pin (108).
(jj) Install the assembled modulator valve onto
separator plate (107). Align the bolt holes.
(kk) Install three 1/4-20x1-3/4 inch bolts (92)
through valve body (93), plate (107) and into
valve body (112).
(ll) After making sure that the plate and valve
body are properly aligned so that all valve body
mounting bolts will pass through them, torque
bolts (92) to 8-12 ft-lb (11-16 N.m).
(mm) Install selector valve (149), drilled end first,
into valve bocy (112). Secure the valve
against dropping out, with a rubber band, cord,
or soft wire.
(nn) Using adjusting ring tool, position adjusting
rings (99, 100, 101, 102 and 103) as they were
before the valve body was disassembled.
(oo) If the valve body assembly is not to be
installed immediately, cover it with a plastic bag
or wrap it to protect it from dust, dirt and
moisture.
6-61
|
