|
| |
TM5-4210-229-14&P
5-16.
CAB ASSEMBLY, LIGHTS, SWITCHES, GAUGES, CONTROLS, AND INDICATORS REPLACEMENT.
(Continued).
c.
Engage hoist and sling to cab. Remove cab by
raising slightly to clear support brackets.
d.
Remove lifting sling and hoist.
INSTALLATION
When lifting an object, make sure the hoist and
sling are fastened securely. Be sure the item
being lifted does not exceed the capacity of the
lifting device.
a.
Install lifting sling and hoist.
b.
Raise cab over chassis and lower into position.
c.
Install front mounting hardware.
d.
Install rear mounting hardware.
e.
Install transfer case shift lever (paragraph 4-160).
f.
Install transmission gear selector (paragraph 4-157).
g.
Connect all electrical lines that run between the cab
and chassis, including the cab-chassis ground strap,
head light wires, horn wires, and brake light switch
(paragraphs 4-147 and 4-148).
h.
Connect speedometer cable (paragraph 4-106).
i.
Install deaeration tank (paragraph 4-59).
j.
Clip brake and clutch lines to cab (paragraph 4-174).
k.
Connect steering coupling (paragraph 4-189).
l.
Connect accelerator linkage (paragraph 4-73).
m. Connect
heater
hoses
at
cab
connections
(paragraph 4-63).
n.
Service radiator (paragraph 4-66).
o.
Install and connect batteries (paragraph 4-83).
p.
Install grille (paragraph 4-123).
5-17.
CAB PANELS REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SET-UP
General Safety Instructions
Batteries disconnected.
Tools
Electric Drill
Materials/Parts
Metal Drill Bits
Sealant (Appendix D, Item 51)
Pneumatic Chisel
Primer Paint (Appendix D, Item 41)
C-Clamps
Finish Paint (Appendix D, Item 40)
Sheet Metal Parts as required
(Appendix E, Figure 95).
5-39
|
