 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-4210-224-14&P
6-20. REAR RETAINER OIL SEAL REPLACEMENT. (Continued)
INSTALLATION
h. Install the speedometedriven gear and new seal
r
(4) and the speedometer cable (3) (paragraph 4-
a.
With gasket surfaces clean, coat the outer
127).
diameter of the new oil seal with sealing
cement (Appendix D, Item 42) .
i.
Install the propeller shaft to the transmission
b. Install the new seal using the rear retainer seal
installer.
j. Install the drain plug (2) and torque to 17 ft-lbs
(23 N ).
m
c. Install the rear bearing retainer cap with a new
gasket (10) on the transmission.
k.
Fill the transmission with new transmission oil
d. Install the upper attaching bolts (8) and torque to
hole.
20 ft-lbs (27 N ).
m
e. Install the lower attaching bolts (8) and torque to
NOTE
30 ft-lbs (40 N ).
m
Capacity is 4.2 qts. (4.0 liters)
f.
Install oil seal (11) and output yoke (7) on
l. Install the oil fill plug (1) and torque to 17 ft-lbs
mainshaft.
(23 N ).
m
g, Using a flange or yoke holding tool, install U-joint
m. Lower the vehicle.
flange retaining nut (6), torque to 100 ft-lbs (135
N ).
m
6-49
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals