 |
|||
|
|
|||
|
Page Title:
Shift Lever and Plunger Removal. |
|
||
| ||||||||||
|
|
 TM 5-4210-224-14&P
5-10. STARTER REPAIR. (Continued)
b. Shift Lever and Plunger Removal.
(1) Remove shift lever pivot bolt (1).
(2) Remove center bearing crews (2) and
s
remove drive gear housing (3) from
armature shaft (4). Shift lever (5) and
plunger assembly (6) will now fall away
from starter clutch.
c. Remove Drive Assembly From Shaft.
If necessary to remove overrunning clutch from
armature shaft, proceed as follows:
(1) Remove thrust washer collar (1) from
armature shaft (2).
(2) Slide a 5/8 inch deep socket or piece of
pipe of suitable size over shaft against
retainer (3) as a driving tool. Tap tool to
move retainer off snap ring (4).
(3) Remove snap ring (4) from groove in
shaft. If snap ring is distorted, it will be
necessary to use a new one on
reassembly.
(4) Remove retainer (3), clutch assembly (5),
from armature shaft (2).
5-21
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals