REAR SUSPENSION STABILIZER BAR REPLACEMENT.

TM 5-4210-224-14 & P

4-240. REAR SUSPENSION SHOCK ABSORBERS REPLACEMENT. (Continued)

b. Torque the nut to 52 ft-lbs (70 N.m).

c. Connect the shock absorber (1) to the axle by lining up the shock absorber with the axle bracket and installng

the bolt (7), spring washer (6), and the nut (5).

d. Torque the nut (5) to 114 ft-lbs (155 N.m).

e. Lower the vehicle to the ground.

4-241. REAR SUSPENSION STABILIZER BAR REPLACEMENT.

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

Tools

General Safety Instructions

Hoist

Engine OFF.

Jack

Transmission in (N) neutral.

General Mechanics Tool Kit

Parking brake and micro-brakelock set.

Materials/Parts

Stabilizer Bar (328132)

REMOVAL

a. Raise the vehicle on a hoist. Support the rear

axle independently of the rest of the vehicle.

b. Disconnect the stabilizer bar (1) from the frame

by removing the nut (2) and washer (3), then

sliding the link bolt (4) out along with the

grommets (5), washers (6), and spacer (7).

c. Remove the stabilizer bar (1) from the anchor

plates (8) by removing the nuts (9), washers

(10), bolts (11) and the clamps (12).

d. Remove the insulators (13) from the stabilizer

bar (1).

INSTALLATION

a. Install the insulators (13) to the stabilizer bar (1).

b. Install the stabilizer bar (1) to the anchor plates

(8) with the clamps (12), bolts (11), washers

(10), and nuts(9).

c. Torque the nuts (9) to 147 ft-lbs (200 N.m).

4-339