 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-4210-224-14&P
4-206. RIMS REPLACEMENT. (Continued)
NOTE
f. A Single Wheel Installation
Be sure pins on clamp ring face
outboard.
(1) Place the wheel and tire assembly in
(2) Turn the wheel until one nut is at the top
position on the hub/rotor and install the
of the bolt circle, then tighten, evenly and
lug nuts, snugly, in a criss-cross pattern to
alternatively to a torque of 140 ft-lbs (190
minimize runout.
N-m).
(2) Turn the wheel until one nut is at the top
of the bolt circle, then tighten evenly and
NOTE
alternatively to a torque of 140 ft-lbs (190
Lateral runout should not exceed
N.m).
0.125 inch (3.18 mm) on the front
wheel and 0.187 inch (4.76 mm) on
g. Dual Wheel Installation
the rear wheels.
(1) Place the inner and outer wheel and
clamp ring in position on the hub/rotor and
h. Inflate tire(s) to 30 psi (450 kPa).
install the lug nuts, snugly, in a criss-cross
i. Lower vehicle.
pattern to minimize runout.
4-282
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals