 |
|||
|
|
|||
|
Page Title:
LUBRICATION INSTRUCTIONS - continued |
|
||
| ||||||||||
|
|
 TM 5-4210-224-14&P
4-9. LUBRICATION IN STRUCTIONS (Continued).
c. Transfer Case Lubrication (Continued).
(4) Transfer Case Service.
(a)
Transfer case fluid should be
changed at 7,500 miles (12,500 km),
then every 30,000 miles (50,000
km).
(b)
Place a clean container below drain
plug (1). Remove fill plug (2), then
remove drain plug (1). Drain the
transfer case fluid.
(c)
Remove container of used transfer
case fluid. Replace drain plug (1).
Using DEXRON II fluid (Appendix D,
Item 32) fill transfer case until fluid is
approximately one inch below fill
plug hole. Replace fill plug (2).
Torque both fill and drain plugs to 32
ft-lbs (44 N-m).
e. Power Steering System Lubrication.
(1) Fluid Level Check.
(a)
Run the engine until it reaches
normal operating temperature, then
shut engine off.
(b)
Remove cap (1) from reservoir (2)
located on streetside front of engine.
(c)
Check fluid level on cap (1) dipstick.
(2) Adjusting Fluid Level. Fluid level should
be between the "HOT" and "COLD" marks
on the fill cap indicator.
4-18
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals