|
| |
TM 5-4210-220-34
3-7.
TRANSMISSION - Continued
(10) Inspect removed valves and springs from main regulator housing. Clean scoured valves with crocus cloth
(item 7, Appendix B). Replace worn or broken springs. Inspect bore holes in housing for damage. Replace
damaged component parts.
(11) Installation of main-pressure regulator and lockup shift valves is done with the aid of spring compressor
J24219. The spring compressor is not required for installation of the converter regulator valve.
(12) Install main-pressure regulator valve (5), small end first, into the bore. Be sure the valve will move freely of
its own weight in its bore.
(13) Install spring (4) and valve stop (3). Place washer (2) on spring (4) and compress the spring into the valve
bore until the snap ring groove is clear. Install snap ring (1).
(14) Install lockup shift valve (10), small end first, into the bore. Be sure the valve will move freely of its own
weight in its bore.
(15) Install spring (9) and valve stop (8). Place washer (7) on spring (9) and compress the spring into the valve
bore until the snap ring groove is clear. Install snap ring (6).
3-36
|
