|
| |
TM 5-4210-220-34
2-18.
TRANSMISSION - Continued
(7)
Using tool J2z4171 remove dust shield and
oil seal from rear cover (output end of
transmission).
(8)
Inspect transmission output shaft bearing in
rear cover. If faulty, refer to General
Support
for
complete
transmission
overhaul.
(9)
Install oil seal, spring-loaded lip first, using
installer J24202-1A (1) and driver handle
J24202-4 (2). Push in until the rear of the
seal (3) is 0.60 - 0.70 in. (15 - 18 mm)
below the surface of the rear cover.
(10) Coat the outer circumference of the dust
shield (5) with seal retainer (item 26,
Appendix B). Install the shield, flat side first,
into the rear cover using installer J24198
(4). The rear edge of the shield must be
flush with the rear surface of the cover.
(11) Coat the threads of the retaining nut with
grease (item 16, Appendix B). Retain yoke
with holder bar and tighten yoke retaining
nut to 600 - 800 ft lb (814 - 1085 Nm).
(12) Replace transmission drain plug and refill
transmission with Dexron (item 9, Appendix
B)
(13) Check transmission oil level while the
vehicle is on level ground and the parking
brake applied. Fill to the COLD RUN band.
(14) Start engine and shift the transmission
through all drive ranges to fill the clutch
cavities and oil passages. Shift to neutral.
(15) When
transmission
reaches
working
temperature check oil level. Top up until oil
is in the HOT RUN band as marked on the
dipstick
2-159
|
