|
| |
TM 5-4210-220-12
4-12. CAB - Continued
(13) Install inside upper door panel (2) using screws (1).
(14) Install inside handle rod (6) to door latch (7) and inside door handle (5) and line window regulator crank
with hole in window glass channel bracket .
(15) Attach lower inside panel (3) using screws (1 and 2).
c.
Window Regulator Repair
NOTE
Window
regulator
cannot
be
repaired. Replace if damaged.
(1) Remove inside lower door panel as detailed
in steps 2 and 3 of Window Repair
procedure (b. preceding).
(2) Remove window regulator attaching screw
(2), flat washers (3) and nuts (4) and
remove window regulator (1).
(3) Inspect
weatherstrip
(5)
and
other
accessible door components. Replace any
found damaged or deteriorated. When
replacing
weatherstrip,
bond
new
weatherstrip in place with contact adhesive
(item 6, Appendix E). Be sure to maintain
1/16 in. (1.5 mm) clearance between ends
of weatherstrip and vertical glass runs.
(4) Install window regulator (1) using screws
(2), flat washers (3) and locknuts (4).
(5) Install inside lower door panel to outer door
panel as detailed in steps 14 and 15 of
Window Repair procedure.
d.
Outside/Inside Door Handle Repair.
NOTE
Door handle cannot be repaired.
Replace if damaged.
(1). Remove inside lower door panel as detailed
in steps 2 and 3 of Window Repair
procedure, b preceding.
(2). When
replacing
outside
door
handle,
disconnect rod (1) from handle (2).
(3). Lift up spring clips (3) and remove keys (4).
4-87
|
