|
| |
TM 5-4210-220-12
4-12. CAB - Continued
INSTALLATION
(1)
Place door on support and aline with door frame. Be sure rod (7) protrudes through door frame.
(2)
Orientate shim (6) so that edge closest to mounting holes faces outward when installed.
(3)
Lubricate screws with white grease (item 34, Appendix E). Position shim between door hinge and door
frame. Attach both hinge and shim to door frame using screws (4) and flat washers (5).
(4)
Check that door is alined with door frame. Loosen screws and realine if necessary.
(5)
Tighten screws to 50 ft lb (65 Nm).
(6)
Install washers (3) and rubber bumpers (2) Install new locknut (1).
REPAIR
a.
Door Hinge Repair
NOTE
Door hinge cannot be repaired. Replace if damaged.
(1)
Remove 12 screws (1) and flat washers (3).
(2)
Clean hinge area on door and, if necessary,
repair paint (see para. 4-9).
(3)
Lubricate screws (1) with white grease (item
34, Appendix E). Attach hinge (2) to door
using screws (1) and washers (3).
b.
Window Repair
NOTE
Window cannot be repaired. Replace if damaged.
(1)
Remove upper door panel (4) by removing
screws (2).
(2)
Remove lower door panel (3) by removing
screws (2 and 1).
(3)
Disconnect inside handle rod (6) from latch
(7) and handle (5).
(4)
Remove screws (8) attaching angle piece
(9).
4-85
|
