|
| |
TM 5-4210-218-13&P
5-3. SCALE FRAME REPAIR (Refer to Figure 5-2)
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Condition
Tools
Reference
General Mechanics Tool Box, Item 1, Section
Scale removed from Recovery / Recharger
III, Appendix B.
Unit; paragraph 4-13.1
Materials/Parts
Self-locking nuts
NOTE
The scale frame consists of angle pieces drilled and bolted. Repair is unlikely but, if required,
would consist of replacement of one or more of the angles.
5-3.1. Removal. (typical)
a.
Remove two nuts (1), washers (2 ), bolts (3) and washers (4) holding each end of piece to be removed.
b.
Remove damaged piece.
5-3.2. Installation. (typical)
a.
Install new piece.
b.
Position and secure with two washers (4), bolts (3), washers (2), and nuts (1) on each end.
5-4
|
