|
| |
TM 5-4210-218-13&P
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
SECTION I. LUBRICATION INSTRUCTIONS
3-1 LUBRICATION OF OTHER MOVING COMPONENTS.
3-1.1 Tool Box Hinges. Lubricate hinges on tool box with general purpose oil (item 7, Section II, Appendix F) every six
months.
3-1.2 Tilt Rack Bearings. Lubricate bearings on tilt rack with general purpose oil (item 7, Section II, Appendix F) every
six months.
Section II. TROUBLESHOOTING PROCEDURES
3-2 GENERAL.
a.
Table 3-1 lists common malfunctions which may be found during operation or maintenance of the Recovery /
Recharger Unit. You should perform the tests/inspections and corrective actions in the order listed.
b.
This manual cannot list all malfunctions that may occur, nor all tests/inspections and corrective actions. If a
malfunction is not listed or is not corrected by listed corrective actions, notify your supervisor.
WARNING
Wear safety glasses or goggles while performing the following procedures.
NOTE
Before you use this table, perform all operation checks listed in the Operator PMCS (table 2-2).
3-1
|
