|
| |
TM 5-4210-218-13&P
mounting extinguisher adapter, an upright mounting two cylinder supports and two adjustable straps, used to hold the
extinguisher securely during recovery operations, charging operations and manual agitation following nitrogen
pressurization.
1-11.6 Transfer Pump Unit (6). Consists of an air motor driven pump unit for the transfer of liquids or vapors in particular
Halon and nitrogen. Requires air supply not to exceed 175 psi. Nominal pump output at 100 psi / 50 cfm air drive and two
stage operation is 2 gpm.
1-11.7 Tool Box (7). Provides for convenient storage of tools, expendable materials, and accessories. The tool box lid is
hinged and provided with wing turn latches for secure closure. The tool box is not attached to the base assembly (10).
1-11.8 Control Panel (8). Provides mounting for the control valves and gauges necessary to operate the pump and
control and direct the flow of Halon and nitrogen in the recovery and charging process.
1-11.9 Halon Hose Assembly (9). Connects the Halon cylinder to appropriate valve on the control panel (8) for the
transfer of Halon to the extinguisher during charging operations. Also used to connect to recovery cylinder during recovery
operations. Has valve to allow isolation of either the Halon or recovery cylinder and an adapter, with gauge to monitor
input pressure to the recovery cylinder.
1-11.10
Base Assembly (10). Provides a portable mounting surface for the recharger. The base is raised from the
floor by support channels to facilitate lifting by forklift. Rings are provided at each corner for attachment of chains, cables,
etc.
1-11.11
Tilt Rack Assembly (11). Consists of a channel, bar, bearing, and frame. The Halon cylinder is initially placed
upright and secured by straps on the channel, then inverted by rotation of the channel around a bearing mounted bar. The
Halon bottle must be inverted for liquid to be pumped to the fire extinguisher.
1-11.12
Cover (12). Provides limited access plus protection from the environment when the recharger is not in use.
Two adjustable straps are provided to secure the cover.
1-12
EQUIPMENT DATA.
Performance data and dimensions for each major Recovery / Recharger Unit component are listed below. Reference the
manual Table of Contents to locate an illustrated parts list for each assembly.
a.
Hoist Winch Assembly.
Rated Lift
600 lb. (272 Kg)
Drum Cable Storage
60 ft (18 m) maximum; 5 ft (1.5 m) supplied
Brake Type
Single disc, automatic
b.
Scale Assembly.
Scale Type
Platform
Scale Range
100 lb. (45 Kg) in 0.25 lb. (0.11 Kg) increments
c.
Scale Frame Assembly.
Length
43.0 in (109.2 cm)
Width
16.0 in (40.6 cm)
Height
40.6 in (103.1 cm)
1-5
|
