|
| |
TM 5-4210-218-13&P
5-8.2. Installation.
a.
Check replacement pump visually for defects. Do not use if defective.
NOTE
Refer to notes on plumbing configuration made during removal.
b.
Install plumbing for unit by first installing all elbow and tee assemblies (15); second installing stage valve (14); third
installing stage valve elbow (13); and fourth connecting all tubing (12).
c.
Install air inlet fitting (16).
d.
Position pump on mounting bracket (8) and align mounting holes.
e.
Install and tighten six washers (11), bolts (10), and nuts (9) to secure transfer pump unit to mounting bracket.
f.
Install pump mounting bracket assembly in position with air motor at rear and align mounting holes.
g.
Install four washers (7), bolts (6), washers (5), and nuts (4) and tighten.
NOTE
Refer to hose tagging or marking for correct reconnection.
NOTE
When connecting transfer pump unit inlet/outlet hoses and motor air inlet hose, insure threads are
clean of any old antiseize tape.
h.
Wrap one layer of antiseize tape (item 3, Section II, Appendix F) around male threads of inlet and outlet hose
adaptors. Also wrap one layer around male threads of air inlet hose adapter.
i.
Connect transfer pump unit inlet (1) and outlet (2) hoses.
j.
Connect air motor air inlet hose (3).
5-22
|
