|
| |
TM 5-4210-218-13&P
d.
Discard part to be replaced.
5-7.2.2. Installation.
a.
Inspect replacement part visually for defects. Do not use if defective.
b.
Place nut (6) on stem (5) with threads toward rounded end of stem
c.
Place retaining ring (7) on stem.
d.
Screw assembly into body (1)and tighten being careful not to mar the stem area where nut slides over.
5-7.3. Outlet Hose Connection Replacement.
5-7.3.1. Removal.
a.
Hold body (1)securely and unscrew connecting elbow (10) from tee (9).
b.
Remove any remaining antiseize tape from tee.
5-7.3.2. Installation.
a.
Inspect replacement nipple visually for defects. Do not use if defective.
b.
Wrap male threads with one layer of antiseize tape (item 3, Section II, Appendix F), install elbow (10) in mounting
hole and tighten.
5-7.4. Safety Relief Valve.
5-7.4.1. Removal.
a.
Hold tee (8) securely and unscrew safety relief valve (9).
b.
Clean mounting hole at any remaining antiseize tape.
5-7.4.2. Installation.
a.
Inspect new safety relief valve for defects. Do not use if defective.
b.
Wrap male threads with one layer of antiseize tape (item 3, Section II, Appendix F), install safety relief valve and
tighten.
5-19
|
