Section I. INTRODUCTION - TM-5-4210-205-35P0006

TM 5-4210-205-35P

SECTION I.

INTRODUCTION

Code

Explanation

Scope

Assemblies which are not procured or stocked

as such, but are made up of two or more

This manual lists repair parts required for the

units.

Such component units carry

performance of direct support, general support, and

individual stock numbers and descriptions,

depot maintenance of the fire truck.

are procured and stocked separately and

can be assembled to form the required

General

assembly

indicated

maintenance

categories.

This Repair Parts and Special Tools List is divided into

Parts and assemblies which are not procured or

the following sections:

stocked and the mortality of which normally

is below that of the end item or component.

a. Repair Parts - Section II. A list of repair

The failure of such part or assembly should

parts authorized for the performance of maintenance at

result in retirement of the end item from the

the direct support, general support, and depot level in

supply system.

figure and item number sequence.

Repair parts which are not procured or stock- ed.

b. Special Tools, Test and Support Equipment

The requirement for such items will be filled

- Section III. A list of special tools, test and support

by use of the next higher assembly or

equipment authorized for the performance of

component.

maintenance at the direct support, general support, and

Repair parts which are not stocked.

The

depot level - Not applicable.

indicated maintenance category requiring

c. Index-Federal

Stock

Number

and

such repair parts will attempt to obtain

Reference Number - Section IV. A list of Federal stock

same through cannibalization. Where such

numbers in ascending numerical sequence followed by a

repair parts are not obtainable through

list of reference numbers in ascending alpha-numeric

cannibalization, requirements will be

sequence, cross-referenced to the illustration figure

requisitioned,

with

accompanying

number and item number.

justification,

through

normal

supply

channels.

Note.

Items not

illustrated

are

cross-

Major assemblies that are procured with PEMA

referenced to page number.

funds for initial issue only as exchange

assemblies at DSU and GSU level. These

Explanation of Columns

assemblies will not be stocked above DSU

and GSU level or returned to depot supply

The following provides an explanation of columns in the

level.

tabular lists in sections II and III.

a. Source, Maintenance, and Recoverability

(2) Maintenance code. Indicates the lowest

Codes (SMR).,

category of maintenance authorized to install the listed

(1) Source code. Indicates the selection status

item.

Repair parts and special tools assigned

and source for the listed item. Source codes used are:

maintenance code "C" may be stocked at the operator

level of maintenance when authorized by the Unit

Code

Explanation

Commander. The maintenance level codes are:

Repair parts which are stocked in or

supplied from the GSA/DSA, or Army

Code

Explanation

supply system and authorized for use

Crew or operator maintenance

at indicated maintenance categories.

Organizational maintenance

Repair parts which are procured and

Direct support maintenance

stocked for insurance purposes because

General support maintenance

the combat or military essentiality of the

Depot maintenance

end item dictates that a minimum quantity

be available in the supply system.

(3) Recoverability code.

Indicates whether

Repair parts which are not procured or stocked,

unservicable items should be returned for recovery or

but are to be manufactured in indicated

salvage.

Items not coded are expendable.

maintenance levels.

Recoverability Codes are:

iii