|
| |
TM 10-4210-235-13
4-14. NOZZLE BRACKET AND QUICK DISCONNECT REPLACEMENT
This task covers a. Removal b Installation
INITIAL SETUP
Tools
Equipment Condition
General Mechanics Tool Kit, Appendix B, Section III,
Close cylinder valves and relieve system pressure per
item 1
paragraph 4-11 steps (1) and (2).
Materials/Parts
Lock Washers (2), Appendix H, item 2
Antisieze Tape, Appendix E, Section II, item 4
a.
Removal (See figure 4-8)
(1)
Release quick coupling half (1) and disconnect hose assembly (2).
(2)
Pull pin (3) and remove nozzle (4) assembly from bracket (5).
(3)
Remove four screws (6) securing nozzle (4) to tie bar (7)
(4)
Remove nipple (8) and coupler (1) from nozzle (4)
(5)
Remove O Ring(9) from coupler (1).
(6)
Remove two nuts (10), lock washers (11), screws (12), flat washers (13), cable (14), and bracket (5)
Discard lock washers.
(7)
Remove cable (14) from pin (3).
b.
Installation
(1)
Assemble new cable (14).
(a)
Push new cable (14) through new cable sleeve (15) and then loop tightly around pin (3) Push cable
end back into cable sleeve Secure by crimping sleeve
(b)
Push loose cable (14) end through another new cable sleeve (15). Push cable end back into cable
sleeve to form a loop just large enough to fit screw (12) body through. Secure by crimping sleeve
(2)
Slip cable (14) onto pin (3)
(3)
Install bracket (5), cable (14), two screws (12), flat washers (13), new lock washers (11), and nuts (10)
4-23
|
