|
| |
TM 10-4210-235-13
Location
Item
Item To Be
Procedure
Not Fully Mission Capable If:
No
Interval
Check/Service
46
After
Hose Assembly
Unwind hose assembly, if It was
used, and clean with water and mild
soap. Dry thoroughly.
Check visible portion of hose
If hose assembly shows evidence of
assembly to see if it is tight and in
leakage, loose connections, dry rot,
good condition with no evidence of
or other visible damage.
leaking or dry rot
If unwound from drum, rewind back
onto drum.
Check that hose assembly is evenly
Hose assembly not evenly wound
wound on drum.
on drum.
47
After
Roller Assembly
Check that roller assembly is in
place, secure and free of binding or
rust.
48
After
Hose Reel
Check that hose reel is secure, free
Drum does not turn freely.
of rust, and drum turns freely with
rewind brake released.
49
After
Rewind Brake
Check Rewind brake to be sure it is
Rewind brake prevents drum from
free of rust and holds drum
turning freely when released.
stationary when applied and does
not bind drum when released.
50
After
Lift Bar
Check that lift bar is free of rust, In
place, and secure.
51
After
Dry Chemical Tank
WARNING
Cap must not be removed
until tank pressure has
been relieved. Severe
injury can result if cap is
removed while tank Is
pressurized.
Check for obstruction in cap vent
Cap vent holes obstructed.
holes.
Check quantity of dry chemical per
Dry chemical supply low.
paragraph 2-9 and 2-10.
Check that cap Is In place and that
Cap missing or tank damaged.
tank Is free of rust and in good
condition.
2-27
|
