|
| |
TM 10-4210-235-13
CHAPTER 5
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS, TOOLS, SPECIAL TOOLS, TEST,
MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE), AND SUPPORT
EQUIPMENT
5-1 REPAIR PARTS.
Repair parts are listed and illustrated in the Repair Parts and Special Tools List TM 10-4210-235-23P.
Mandatory replacement parts are listed in the Mandatory Replacement Parts list, appendix H.
5-2 COMMON TOOLS AND EQUIPMENT.
Tools and test equipment requirements are listed m the Maintenance Allocation Chart TM 10-4210-235-13,
appendix B. For authorized common tools and equipment, refer to the Modified Table of Organization and
Equipment (MTOE), CTA 50-970, as applicable to your unit.
5-3 SPECIAL TOOLS
The following special tool is required for direct support maintenance. Use of this tool is described in Section Ill of
this chapter.
Spanner Wrench (39428) 5472A1.
Section II. TROUBLESHOOTING
5-4 TROUBLESHOOTING
Direct support troubleshooting procedures are not required.
Section III. MAINTENANCE PROCEDURES
5-5. GENERAL
The procedures m this section have been arranged In the order in which the items appear m the Unit (0)
maintenance level column on the Maintenance Allocation Chart (MAC) which is provided in Appendix B. Step-
by-step procedures have been provided for all actions authorized to be performed by unit maintenance in the
order in which they appear on the MAC. Actions authorized to be performed by direct support maintenance have
been duly noted: step-by-step procedures for these actions may be found in chapter 5.
5-1
|
