|
| |
TM 10-4210-235-13
b.
Installation
(1)
Install jack stand (3) with holes facing side of trailer (1).
(2)
Install handle (2) into frame (1) and through either jack stand (3) hole as appropriate.
(3)
Remove jack stands using jack to lift then lower rear of trailer (1).
4-27. JACK STAND (FRONT) REPLACEMENT.
This task covers:
a.
Removal
b.
installation
INITIAL SETUP:
Tools
General Safety Instructions
Jack (Two Capacity), Appendix B, Section III, Item 2
WARNING
Jack Stands (2) (Two Ton Capacity), Appendix B,
Section III, item 2
Performing maintenance on equipment that is not
properly supported can result in equipment falling or
Equipment Condition:
being dropped causing personal injury.
Set Parking Brakes (para 4-29).
a.
Removal (See figure 4-29.)
WARNING
Performing maintenance on equipment that is not properly supported can result in equipment
falling or being dropped causing personal injury.
(1)
Lift front of trailer (1) using jack and support with jack stands.
(2)
Remove clip (2) and pin (3).
(3)
Remove jack (4).
4-65
|
