Chapter 5. FINAL INSPECTION

TM 9-4931-363-14&P

CHAPTER 5

FINAL INSPECTION

c. Inspect the test set container to insure that the clasp

5-1. General.

fasteners secure the lid firmly to the bottom section and

that the seal between the two sections is undamaged.

References to tests and procedures for final inspection

of the fire control subsystem test set after repairs have been

5-3. Other Components.

completed are provided in this chapter. If no deficiencies

In accordance with the procedures of paragraph 4-3,

are found, the test set is ready to be returned to the user or

inspect the LOD, the helmet boresight tool, the circuit card

to stock.

extractor, the connector shorting assembly, and the four

cables, all of which are stored in the lid of the test set

5-2. Test Set Subassembly.

container. Give special attention to the borescope angle

bracket of the LOD to insure that it is not bent or twisted

out of alignment.

a. V i s u a l l y i n s p e c t t h e t e s t s e t s u b a s s e m b l y i n

accordance with the procedures in paragraph 4-3.

5-4. Organizational HSS Boresight Kit.

Inspect in accordance with the procedures of paragraph

b. Perform the divider network adjustments (paragraph

4-23) and the test set self-test procedures (paragraph 3-6).