HSS Test Theory.

TM 9-4931-363-14&P

J1-T. The other two input simulation signals are connected

2-3 and in the HSS test table. With S9 set to R3, the three

to J1-S and J1-U of the EIA. With the linkages in their BIT

error signal outputs of the pilot linkage are displayed as the

brackets, three error signals of amplitude and phase

METER SELECT switch is set to positions 2, 3, and 4,

specified in the HSS test table are connected from J1-P, -p,

which correspond to steps 9, 10, and 11 in figure 2-3 and in

the HSS test table.

and -j of the EIA; through cable W2; through J1-P, -R, and

-W of the test set connector; through the S9 connections

NOTE

shown on figure 2-3 for those test set pins; and through

wipers 1 and 2 of S5-A to the test set meter and to the test

Steps 8 and 12 in the HSS test table are

set phase detector circuit on card A2. With S9 set to R2,

basically mechanical (adjustment of the linkage

the three error signal outputs of the gunner linkage are

BIT bracket) and are not, therefore, specifically

displayed as the METER SELECT switch is set to positions

called out above.

2, 3, and 4, which correspond to steps 5, 6, and 7 in figure

2-10