Figure 10. Alarm Bell Replacement

TM 55-1925-292-14&P

0026 00

WARNING

Replace or repair components only after the affected circuit has been secured,

locked out and tagged out (FM 55-502). Performing replacement with the circuit

energized may result in injury.

5. Using a multimeter, check for voltage at the terminals (figure 10, item 7) to ensure that electrical circuits are

deenergized. If voltage is present, ensure that the proper circuit breakers are set to OFF, locked out, and

tagged out (FM 55-502). If no voltage is present, proceed with the procedure.

6. Label and remove the wiring from the terminals (figure 10, item 7), and remove the cover (figure 10, item 4).

7. Loosen and remove the four bolts (figure 10, item 8) and lockwashers (figure 10, item 9) that secure the

actuator assembly, and remove it from the mounting bracket. Discard the lockwashers.

Figure 10. Alarm Bell Replacement

0026 00-12