TEST OR INSPECTION
Turn battery disconnect switch to OFF position (WP 0007). Remove jumperwire and
reconnect from pump house wire harness pump house diagnostic module connector.
Open passenger side stowage compartment P1 door (WP 0010). Disconnect and
install a jumperwire into passenger side body wire harness rear compartment
thermostat module connector, terminal A wire 2852 and terminal B wire 4093. Turn
battery disconnect switch to ON position (WP 0007). Check if rear compartment heater
If rear compartment heater operates, go to Step 3.
If rear compartment heater attempts to start or starts and shuts down,
go to Step 6.
If rear compartment heater does not attempt to start, go to Step 19.