TEST OR INSPECTION
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
Turn battery disconnect switch to OFF position (WP 0007). Place instrument panel in
service position (TM 9-2320-325-14&P). Remove flasher relay (TM 9-2320-325-14&P).
Install a test lead set between flasher relay terminal wire 1080 and "Flasher'" yellow
wire. Remove left side clearance/turn light (WP 0344). Turn battery disconnect switch
to ON position (WP 0007). Turn Service Drive Lights On (TM 9-2320-347-10). Turn left
turn signal on (TM 9-2320-325-14&P). With a test lead set, check for 22 to 28 VDC
between main wire harness wire 1411 (yellow) at driver side clearance/turn light
connector, terminal 3 and a known good ground.
If 22 to 28 VDC are present, replace left side clearance/turn light (WP 0344).