6-49. TORQUE CONVERTER STATOR - Continued
Install roller bearing (6) on roller race (7).
Install roller race (7) in stator (1) until roller bearing (6) is near stator roller holder.
Remove stator roller holder by pulling on attached string.
Push roller race (7) inward while turning roller race clockwise until roller bearing (6) seats.
Position stator (1) with roller race (7) up.
Turn roller race (7) counterclockwise to
lock in place.
Keep outer face of stator down so bearings and
springs will not fall out.
Hold stator (1) with thrust pads (2) away
from transmission (3).
Stator must turn freely in clockwise direction and
lock up in counterclockwise direction to operate
properly and prevent damage to equipment.
Install stator (1) on shaft (4).