|
| |
TM 5-4210-233-14&P-1
5-42. REAR TANDEM AXLE AND DIFFERENTIAL-Continued
(44)
Apply silicone gasket material (Item 35, Appendix E) to carrier (8) mounting surface. Use a lifting
device and straps to lift the differential carrier into position on the axle housing. Install four
washers (12), four screws (11) and eight washers (10) and screws (9). Do not tighten screws (9) at
this time.
(45)
Carefully push the carrier into position in axle housing. Torque the four screws (9) to a torque of 75
to 115 lb ft (102 to 156 Nm).
(46)
Install and torque the remaining washers (10) and screws (8).
(47)
Install pipe plugs (6 and 7) and breathers (45 in housing.
(48)
The axle shafts (2 and 3) will be installed when axle assembly is installed on the truck.
5-282
|
