|
| |
TM 5-4210-233-14&P-1
5-42. REAR TANDEM AXLE AND DIFFERENTIAL-Continued
(b) Use guide studs to align the shims (27). Align oil slots in shim pack (27) with oil slots in bearing
cage (28) and carrier (36). Use a minimum of three shims (29). If the pack has shims of different
thickness, install the thinnest shims on both sides of the pack for maximum sealing.
(c) Install the drive pinion (18) and bearing cage (28) into the carrier (36). If necessary, use a Rubber
hammer or leather mallet to top the assembly into position.
(16)
Secure the bearing cage (28) to the carrier (36) with eight washers (23) and screws (24). Torque
screws to 50 to 75 lb ft (68 to 102 Nm).
(17)
Install deflector (22) and yoke (20) on drive pinion (8). Install nut (21) and torque to 300 to 400 lb ft
(203 to 407 Nm).
(18)
If ring gear (1) was removed from case assembly (9), install ring gear (1) on flange case half (9).
(a) Place ring gear (11) on case half (9) with screw holes aligned.
(b) Install twelve screws (17) with head against gear (18) face. Install washers (16) and nuts (15) to
secure ring gear (8).
(c) Torque nuts to 85 to 115 lb ft (115 to 156 Nm).
5-270
|
