4-65. STOP, TURN AND TAIL LIGHTS-Continued
Attach wiring harness to reflector assembly (7).
Install reflector assembly with four screws (6).
Install three bulbs (5).
Install lens (3) in ring (2) and secure by turning two tabs inside ring (2).
Test stop, turn and tail lights as follows:
Turn battery switch on.
(b) Turn headlights on. One taillight bulb should illuminate.
(c) Step on brake pedal. Second bulb should illuminate.
(d) Actuate turn signal switch in both directions. Turn signal lights should flash.
Install gasket (4) and ring (2) and secure with four screws (1).
Connect batteries (see para 4-114).