Quantcast Cleaning and Inspection - TM-5-4210-233-14P-1_343

Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: Cleaning and Inspection
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Disassembly - TM-5-4210-233-14P-1_342
Up
TM-5-4210-233-14P-1 Twin Agent 4x4 Firefighting Truck Model No. CM-KFT-B Manual
Next
Installation - TM-5-4210-233-14P-1_344
TM 5-4210-233-14&P-1 4-40. FLUSH VALVE- Continued c. Cleaning and Inspection. WARNING Dry cleaning solvent P-D-680 is potentially dangerous. Avoid repeated and prolonged breathing of vapors and skin contact with the liquid.  Do not use near open flame, arcing equipment or other ignition sources.  Always wear eye protection and protective clothing.  The flash point of P-D-680 is 100 to 138 deg. F (38 to 59 deg. C). (1) Clean all parts in dry cleaning solvent (Item 3, Appendix E). WARNING Death or serious injury could occur if compressed air is directed against the skin.  Do not use compressed air for cleaning or drying unless the pressure is/has been reduced to 30 psi (2.11 kg/cm2) or less.  When working with compressed air, always use chip guards, eye protec- tion, and other personal protective equipment. (2) Dry all parts with compressed air. (3) Inspect valve body (2) for cracks and damaged threads.  Replace as necessary. (4) Inspect ball valve (1 3) for grooves or cracks.  Replace as necessary. d. Assembly. (1) Install new actuator shaft O-ring (15) and actuator shaft (14).  Apply a thin coat of silicone grease (Item 11, Appendix E) to actuator shaft. (2) Fit ball valve (13) to actuator shaft (14). (3) Install new pivot bolt O-ring (12) and pivot bolt (11).  Apply a thin coat of silicone grease (Item 11, Appendix E) to O-ring. (4) Install new seat O-ring (5) and new seat (4) in new seat retainer (1).  Apply a thin coat of silicone grease (Item 11, Appendix E) to O-ring. (5) Install  new  retainer  O-ring  (3).    Apply  a  thin  coat  of  silicone  grease  (Item  11,  Appendix  E)  to inside edge of seat retainer. (6) Use a spanner wrench to thread seat retainer (1) clockwise into valve body (2) until tight. (7) Install two stop plates (10) to original position on actuator shaft (14). (8) Install new handle O-ring (9).  Apply a thin coat of silicone grease (Item 11, Appendix E) to O- ring. (9) Install handle (8) to original position. 4-214

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc.
6230 Stone Rd, Unit Q Port Richey, FL 34668

Phone For Parts Inquiries: (727) 493-0744
Google +