5-63. MONITOR AND NOZZLE
This task covers:
Cleaning and Inspection d. Follow-on Maintenance
Tool Kit, General Mechanics, Automotive
(Appendix B, Section III, Item 1)
(Item 7, Appendix E)
Butt Connectors (Item 27, Appendix E)
Shop Equipment, Automotive
Tags, Identification (Item 32, Appendix E)
Maintenance and Repair
Silicone Sealant (Item 35, Appendix E)
(Appendix B, Section III, Item 4)
Grease, Silicone (Item 11, Appendix E)
Dry Cleaning Solvent (Item 3, Appendix E)
Pipe Thread Sealing Compound
(Item 2, Appendix E)
(Item 47, Appendix E)
O-rings (Figure 200, Appendix F)
Monitor and Nozzle Removed (see para 4-202.)
Tag and disconnect nozzle motor cable (1). Unscrew nozzle (2) from outlet tee (3).
Remove RAISE/LOWER motor (4) from siamese (5) as follows:
(a) Note position of gear guard (6) on mounting plate (7). Remove five screws (8) and remove
RAISEILOWER motor (4) from mounting plate (7).
(b) Remove four screws (10) and cover (11) from electrical box on motor (4).
(c) Tag and disconnect wires in electrical box on motor (4). Unscrew cable grips (12 and 12A) and
remove cable assemblies (1 and 13).
Remove RIGHT/LEFT (rotational) motor (14) from base (15) as follows:
(a) Remove four socket head capscrews (16) and remove mounting bracket (17) with motor (14) from
(b) Note position and orientation of motor (14) on bracket (17) and scribe match marks on bracket and
motor (14). Remove five capscrews (18) and remove motor (14) from bracket (17).
(c) Remove four screws (19) and cover (20) from electrical box on motor (14).
(d) Tag and disconnect wires in electrical box on motor. Unscrew cable grips (21 and 22) and remove
cable assemblies (13 and 23) from electrical box on motor (14).
Remove hex head screw (24) and remove outlet tee (3) from siamese (5).
Remove and discard O-rings (25) and (26).