Assembly-continued -706880943

TM 5-4210-233-14&P-1

5-42. REAR TANDEM AXLE AND DIFFERENTIAL-Continued

(28)

Install the differential assembly in a vise with soft jaws. Install the resistance tool in the differential

to mate with splines in the spider.

(29)

Use a torque wrench to rotate resistance tool. Rotate tool and read the torque value on torque

wrench. Rotating resistance should be a maximum 50 lb ft (67.8 Nm).

(30)

If rotating torque exceeds specifications, disassemble the gears and check for any problem that

causes torque to exceed specification. Repair or replace any parts that could impede rotating

resistance.

(31)

Assemble parts and again check rotating resistance.

(32)

Apply axle lubricant to inner diameter of bearing cups (35) and bearing cones (19). Install bearing

cups (35) and bearing cones (19) on differential case assembly (37).

WARNING

Serious injury could occur if heavy equipment is moved/lifted

without sufficient personnel to do the job. Use proper physical

lifting procedures or use a suitable lifting device or dolly. Wear

safety shoes, gloves and other suitable protective clothing. Area

should be clear of other personnel. Serious injury or death can

result from falling objects.

(33)

Install adhesive to bearing bores of carrier bearing caps (36). Attach a strap to differential case

assembly and, using a lifting device, lift differential case assembly (37) into position on carrier (38).

5-273